How to Fit your Number Plates: A Step-by-Step Guide

Replacement Number Plates are becoming increasingly popular for vehicle owners looking to upgrade the look of their car with the Gel and 4D styles we offer. However, many customers make mistakes when fitting these Number Plates and cause damage to the acrylic or gel letters.

In this guide, we will walk you through the step-by-step process of installing Gel, 4D and Standard Printed Number Plates securely to ensure longevity and compliance with Legal Standards, as well as the common mistakes to avoid.

Tools Required for Installing Number Plates

Before you begin the installation, gather the necessary tools and materials:

  • Screwdriver (Flathead or Phillips) - To remove the old number plates and secure the new ones.
  • Drill (Optional) - For drilling holes if required.
  • Spirit Level - To ensure proper alignment.
  • Cleaning Cloth - For surface cleaning before attaching new number plates.

We highly recommend the use of our Fitting Kits when fitting Gel and 4D Number Plates. These contain all screws and screw caps as well as 6 adhesive sticky pads that will help you fit your new plates.

Step-by-Step Installation Guide

Step 1: Remove the Old Number Plates

  • Unscrew the existing number plate if it is secured with screws.
  • If its is secured with adhesive sticky pads, gently pull the plates away from the car.

Step 2: Clean the Mounting Area

  • Use a damp cloth with warm soapy water to remove any dirt, dust or adhesive residue.
  • Ensure the surface if completely dry before attaching the new plate.

Step 3: Attaching with Screws (Drill Method)

  • Hold the new number plate in position to check the alignment using a spirit level.
  • Carefully, drill through the number plate in the place where the screws will align to the car. (DO NOT DRILL THROUGH ANY GEL OR 4D LETTERS).
  • Insert the screws and tighten them until the plate is secure. Be careful not to overtighten them as it may crack the acrylic.

Step 4: Using Adhesive Sticky Pads (No-Drill Method)

  • If you prefer a cleaner installation (recommended for Gel and 4D Number Plates) apply strong double-sided adhesive pads to the back of the number plate.
  • TOP TIP - Use a hair dryer or something similar to heat and activate the glue, making them extra strong when fixing your plate.
  • Firmly press the plate onto the cleaned surface, holding it in place for a few second to ensure proper adhesion.
  • Allow the adhesive to set for a few hours before driving.

Common Mistakes to Avoid

Misalignment

Always use a spirit level to position the plate correctly before securing it

Weak Adhesion

Ensure the surface is clean and dry to avoid adhesive pads from peeling off

Over-Tightening Screws

Applying too much force may damage the acrylic